Root your Samsung Galaxy J2 Prime G532F/M

by

This root file is for J2 Prime_G532F/M/

***** For NETWORK UNLOCK ONLY or for LOWER PATCH LEVEL ONLY *****

I have already tried and tested this method. Use this root file if you are going to unlock(network unlock) your phone only or if you still have lower patch level of this particular phone (if there is one).

If you have higher patch level you will end up with reboot loop phone after you hardreset your phone. The only way to fix it is to reflash the firmware of your phone.

Download These Files First before proceeding

(adsbygoogle = window.adsbygoogle || []).push({});

(adsbygoogle = window.adsbygoogle || []).push({}); “If you are having hard time downloading the file in datafilehost make sure to UNCHECK “DOWNLOAD WITH SECURED DOWNLOAD MANAGER” below DOWNLOAD button”


Odin –> Odin 3.12
Root File –> Download here

Samsung Driver — > SamsungDriver

“Extract these files in your desired folder”

Installing the driver

1. Install driver first just keep on hitting next. (Open/Execute/Run SamsungDrivePack)
2. After installing the driver Press and Hold Volume Down + Home Key + Power Button, a selection will appear if you would like to go in Download Mode, Press Volume Up to proceed in Download Mode.
3. Connect your phone in the PC via USB Cable
4. Wait for it to finish installing the driver.
“Note: Sometimes it is better to reboot your PC. After installing the driver.”


BEFORE PROCEEDING IN FLASHING MAKE SURE  THAT THE BATTERY IS FULLY CHARGED OR 50% CHARGED.

Flashing your Phone

1. Open Odin 3.07
2. Load the file (PDA). Click on PDA then look for the ROOT FILE that you had downloaded.

Picture is example only.

3. Do not check repartition. 

4. When you are ready to flash your phone, Press and Hold Volume Down + Home Key + Power Button, a selection will appear if you would like to go in Download Mode, Press Volume Up to proceed in Download Mode.
5. Connect your phone in the PC via USB Cable, wait for a value in the ID:COM to appear. It will turn yellow with number example: COM32, if it nothing appear close Odin an open it again and load the file again.
6. Press START to proceed flashing your phone. Wait until it is done, the phone will reboot after flashing.

I hope this tutorial help you. Drop a comment if there is something is not clear to you. Cheers! ^_^

Make sure to leave a feedback 😉

GET 1 USD FOR LINK DOWNLOAD

NOTE: contact via email [email protected] , i will sent link download for you

More from my site