Cherry Mobile Sapphire 2.0 Stock ROM/firmware to unbrick your phone

If you do not have the driver. I also provide the driver. Or you can go to my Tools section and find MTK SPD Driver.

 
TOOLS
ResearchDownload –> DOWNLOAD HERE
Firmware –> Download HERE
Driver — > DOWNLOAD HERE

DOWNLOAD THE FILES, AND EXTRACT. INSTALL DRIVER.

To install the driver

1. Extract SPD SCI-android-usb-driver.zip anywhere you want
2. Open SPD SCI-android-usb-driver
3. Open x86 folder
4. Open DPInst.exe this will install the driver.

There are two ways you can use this firmware.
1. To fully flash your phone
2. To remove password, pattern lock, and gmail account.

TO remove password, pattern lock and gmail account.
1. Open Researchdownload
2. Load packet and look for file(first button)
3.  Check only the following
✓FDL1✓FDL2✓UserData
4. Click in calibration/backup page, and UNCHECK ALL and press OK
5. And lastly press the Play button to continue flashing.

TO fully flash your phone.
1. Open Researchdownload
2. Load packet and look for file(first button)
3. Remove check in the following selection
✓EraseRuntimeNV
✓PHASE_CHECK
✓EraseCache
✓EraseData
✓EraseMisc
4. Click in Calibration/BACK UP page, and UNCHECK ALL and press OK
5. Press Play button
6. Press and Hold VOLUME UP and VOLUME DOWN and insert USB cable. (your phone must be turned off)
7. Repeat number 6 if your phone is not detected by researchdownload.
8. If detected by research download just wait until the flashing is done and it should reboot your phone automatically.

I hope this tutorial help you recover your phone 🙂